Brodit holder/charger Honeywell EDA10A cig.plug

RRP €184.95

Fast Shipping
High Quality Products
Secure Payments

Details

More Information

Compatibility

Instruction

Details

Use an active holder for your EDA10A and you will always have a freshly charged battery! The holder provides a neat and comfortable installation - safe and convenient. The holder is equipped with a cig-plug for connection to the vehicle's 12/24 Volt socket. 3A charging. Charging via pogo plug.

This holder is to be used when you want to have your EDA10A extra securely in place and still have it easy accessable.

The holder is equipped with a tilt swivel so you can easily adjust the angle for better viewing. Tilts 17° and swivels 360°. Mounting plate 42x50 mm with 4 mm AMPS-holes. Made of high grade black ABS/Acetal plastic. Made in Sweden.

More Information

More Information
Accessory brand	Brodit
Barcode	7320287124002
Recommended retail price incl. VAT	€184.95
Device with or without case	nee
Holder feature	Toestelspecifiek
Cable / Qi / charger type / connnector	Molex, sig plug, piggy tail (Easy Switching)
Charge device via	Pogo / Pins
Input Voltage	12/24V geschikt
Voltage (output)	5V
Max Amperage	3,0 Amp
Montage standaard	AMPS, VESA
Device holder lockable?	ja spring stud locking
Color	black
Productinfo	Brodit houder

Show more + Show less -

Compatibility

Show more + Show less -

Instruction

1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.

2. To place the device in the holder: Press the spring stud locking upward. Place the lower part of the device in the holder, then flip/press the upper part forwards so it snaps into place in the holder. Press the spring stud locking downward.

3. To remove the device from the holder: Press the spring stud locking upward. Press upwards on the upper part of the holder, in the same time pull the upper part of the device out from the holder and then lift the device up and out from the holder.