Brodit fixed installation holder Huawei P30

RRP €97.95

Fast Shipping
High Quality Products
Secure Payments

Details

More Information

Compatibility

Instruction

Details

Keep your phone's battery fully charged in an active holder, always within easy sight and reach! Neat, discreet and convenient. Custom made with a perfect, firm fit. For fixed installation. The holder is to be connected inside the dashboard, providing an elegant installation without any cables hanging over the interior. You have full access to the camera and all buttons when the device is in the holder. It is easy to slide the phone in place in the holder so it connects to the charging, and to take it out of the holder when leaving the vehicle.

Supports quick charging.

The holder is equipped with a tilt swivel so you can easily adjust the angle for better viewing, or switch between portrait and landscape mode. Tilts 17° and swivels 360°. Mounting plate 42x50 mm with AMPS-holes. Made of high grade black ABS/Acetal plastic. Made in Sweden. Connect the power cable with a 2A fuse. Professional installation recommended. Attach onto ProClip Mounting Platform.

More Information

More Information
Accessory brand	Brodit
Barcode	7320287271201
Recommended retail price incl. VAT	€97.95
Holder feature	Toestelspecifiek
Charge device via	usbC
Device with or without case	nee
Cable / Qi / charger type / connnector	Molex, fixed install
Input Voltage	12/24V geschikt
Voltage (output)	QC - QuickCharge
Max Amperage	3,0 Amp
Montage standaard	AMPS
Device holder lockable?	no
Color	black
Productinfo	Brodit houder
Product installation	Mount the holder on a ProClip in your vehicle. A detailed installation manual is included in the product packaging
Product suitable for info	In the Compatibility tab, check whether your smartdevice is suitable or listed for this holder

Show more + Show less -

Compatibility

Show more + Show less -

Instruction

2. Connect the Red wire to a 12 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle.
Installation of the holder: 1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. 2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel.

3. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.