Brodit holder fixed install. iZettle Reader

RRP €101.95

Fast Shipping
High Quality Products
Secure Payments

Details

More Information

Compatibility

Instruction

Details

An active holder which is to be connected inside the dashboard, this gives a discreet, neat installation without cables hanging over the interior!

You can choose to use the holder as an active holder for charging of your device only, or to connect an adapter to the Molex connector for additional features. Then you can use the holder also for other own solutions.

12/24 Volt. The product is E-approved. Connect the power cable with a 2 A fuse. 2 A charger. Professional installation recommended. The holder is attached onto a tilt swivel so you can easily adjust your device in order to avoid light reflection. Attach onto a ProClip Mounting Platform.

Dimensions: 75 x 79 x 47 mm (W x H x D mm)
Weight: 158 g
Cable length: Total length: 244 cm (Holder to box: 74 cm, Connectors+box 11 cm, Box to open end: 159 cm.)

Charging specifications:
Input voltage: DC/10-30V
Charging voltage: DC/4.75-5.3V
Output current(Typ): 2.0A
Input & output protection: Input polarity reversal/Output over voltage/Output over current/Output short protection
LED charging indicator: Power input indicator(Green), Ovp/Ocp/Output short(Red)
Operating temperature: 0°C ~ +40°C
Storage temperature: -20°C ~ +80°C
RoHS compliant: ROHS

More Information

More Information
Accessory brand	Brodit
Barcode	7320285139350
Recommended retail price incl. VAT	€101.95
Device with or without case	nee
Holder feature	Toestelspecifiek
Cable / Qi / charger type / connnector	Molex, fixed install
Input Voltage	12/24V geschikt
Voltage (output)	QC - QuickCharge
Max Amperage	3,0 Amp
Montage standaard	AMPS
Device holder lockable?	no
Color	black
Productinfo	Brodit houder
Product installation	Mount the holder on a ProClip in your vehicle. A detailed installation manual is included in the product packaging
Product suitable for info	In the Compatibility tab, check whether your smartdevice is suitable or listed for this holder

Show more + Show less -

Compatibility

Show more + Show less -

Instruction

2. Connect the Red wire to a 12/24 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle. How to mount the holder: 1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. 2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws.

3. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw firm at first, then loosen it a bit so the holder is firmly in place, but still can be adjusted.