Brodit holder fixed install. Samsung Galaxy S7 Edge

RRP €97.95

Fast Shipping
High Quality Products
Secure Payments

Details

More Information

Compatibility

Instruction

Details

An active holder which is to be connected inside the dashboard, this gives a discreet, neat installation without cables hanging over the interior! The holder is attached onto a tilt swivel and can be adjusted in order to avoid light reflection. Attach onto ProClip Mounting Platform in your car.

With Molex adapter system. You can choose to use the holder as an active holder for charging of your device only, or to connect an adapter to the Molex connector for additional features. Then you can use the holder also for power supply of a GPS receiver or other own solutions (can not be used for data communication or audio connection).

The product is E-approved. 12/24 Volt. Connect the power cable with a 2 A fuse. 2 A charger. Professional installation recommended.

Charging specifications:
Input voltage: DC/10-30V
Charging voltage: DC/4.75-5.3V
Output current(Typ): 2.0A
Input & output protection: Input polarity reversal/Output over voltage/Output over current/Output short protection
LED charging indicator: Power input indicator(Green), Ovp/Ocp/Output short(Red)
Operating temperature: 0°C ~ +40°C
Storage temperature: -20°C ~ +80°C
RoHS compliant: ROHS

More Information

More Information
Accessory brand	Brodit
Barcode	7320285138667
Recommended retail price incl. VAT	€97.95
Holder feature	Toestelspecifiek
Charge device via	usbC
Device with or without case	nee
Cable / Qi / charger type / connnector	Molex, fixed install
Input Voltage	12/24V geschikt
Voltage (output)	QC - QuickCharge
Max Amperage	3,0 Amp
Montage standaard	AMPS
Device holder lockable?	no
Color	black
Productinfo	Brodit houder
Product installation	Mount the holder on a ProClip in your vehicle. A detailed installation manual is included in the product packaging
Product suitable for info	In the Compatibility tab, check whether your smartdevice is suitable or listed for this holder

Show more + Show less -

Compatibility

Show more + Show less -

Instruction

2. Connect the Red wire to a 12/24 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle. How to mount the holder: 1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. 2. Place the attaching plate onto the desired position.

3. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.